Megatron MPP101 Spezifikationen

INSTALLATION AND OPERATION Setting Up Removing the Battery Fresh Seal To start operating the printer, pull out the battery fresh seal as shown on Fig

INSTALLATION AND OPERATION Plug the Power Supply Adapter into the mains outlet and connect it to the MPP101 printer as shown on Figure 4. Make sure t

INSTALLATION AND OPERATION Bluetooth Connection Range To establish a proper communication with the printer, it should be placed not far than 10 m fro

MAINTENANCE Changing the Paper Roll Open the Paper Bin pressing the two sides of the cover as shown on Figure 6. Figure 6. Opening the Paper Bin Re

MAINTENANCE Figure 8. Pulling Out the Paper Cleaning the Print Head Disconnect the printer from the power supply adapter. Open the paper bin cover

MAINTENANCE Changing the Batteries Remove the belt clip as shown on Figure 10. Figure 10. Removing the Belt Clip Open the battery compartment as s

MAINTENANCE Figure 12. Placing the Batteries Close the battery compartment and attach the belt clip pushing it to the printer base and sliding it t

TROUBLESHOOTING Problem Check State Action Battery fresh seal? In place Remove it! Are the batteries in place? No batteries Install Batteries!

SOFTWARE Installation Instructions Windows 2000/XP Operating System Step 1. Unzip the installation file install.zip into a folder of your choice. St

SOFTWARE Figure 15. Select a Printer Port Step 5. Press the Have Disk button. Browse to the folder, where the install.zip file was unzipped (See

DISCLAIMER:  While every effort has been made to ensure that the information in this manual is accurate and complete, no liability can be accepted f

SOFTWARE Operating Instructions Windows 2000/XP Operating System Before start printing with MPP101 you need to change the port settings in the printe

SOFTWARE Figure 18. Ports Properties Step 3. Disable the bidirectional support (Enable bidirectional support should not be checked). The rest o

TECHNICAL SPECIFICATIONS Print Method Thermal dot line printing Number of dots/line 384 Printing Width (mm) 48 mm Dots density (dot/mm) 8 P

TECHNICAL SPECIFICATIONS Graphics logos (bit x dot) 3 x (384 x 240) Printing speed (mm/s) up to 70* Power supply 5 NiMh rechargeable batteri

CONTENTS READ THIS FIRST 4 Safety Precautions ... 4 Warnings ...

READ THIS FIRST Safety Precautions  Before using the printer, please ensure that you have read and understood the safety precautions described belo

READ THIS FIRST contact with liquids or salt air, wipe it dry with a soft, absorbent cloth. If water or other foreign substances enter the interior,

READ THIS FIRST  Do not attempt to disassemble, alter or apply heat to the batteries. There is serious risk of injury due to an explosion. Immediat

READ THIS FIRST Exposure to intense sunlight and heat may cause the batteries to leak, overheat or explode, resulting in fire, burns or other injurie

INTRODUCTION Unpacking the printer Remove the printer from its carton being careful not to damage the packing material so that it may be re-used if t

INTRODUCTION 978 Figure 2. Bottom View 7. Battery Compartment 8. Belt Clip 9. Battery Fresh Seal MPP101 User Manual 9